Search Results

System Sensor L-Series speakers reduce costly ground faults using a plug-in design and universal mounting plate that allow the installer to pre-wire mounting plates, dress the wires, and confirm wiring continuity before plugging in the speakers.

The DST family of sampling tubes are pieces of steel piping with a series of holes drilled the entire length of the tube and should extend the entire width of the duct. The correct length has to be chosen for width of the duct where it will be installed. The sampling tube length must extend at least 5/8 across the duct width for optimal performance. The sampling tube is always installed with the air inlet holes facing into the air flow. The tubes lock securely into place and can be removed by releasing the front or rear locking tab.

L-Series Surface Mount Back Boxes are the best solution in locations where you have a hard surface to mount to.

L-Series horns are designed to simplify installations to provide primary and secondary signaling for fire and security applications.

The System Sensor L-Series LED strobes are rich with features that increase application versatility, simplify installation, and maximize profits with lower current draw and modern aesthetics. LED lighting technology offers significantly lower current draw compared to older Xenon bulbs across a full candela range. This improves design flexibility for notification appliance circuits (NACs) while also reducing power supply requirements, allowing for simpler and lower-cost installations.

In addition, the System Sensor L-Series with LED notification appliances offer a new diagnostic test point feature that allows you to measure device voltage with a digital voltage meter (DVM) without removing the appliance from the wall or ceiling. The DVM test points are discreetly located on the face of the notification appliance, which enables faster troubleshooting and end-of-line (EOL) voltage checks while greatly reducing the risk of misplacing or damaging appliances during troubleshooting.

i³™ Series offers conventional smoke detectors with sounder, relay and isolator features included.

System Sensor L-Series LED color lenses come in four colors options: amber, blue, green, and red. The lenses are compatible with L-Series strobes including wall- or ceiling-mount. These color lenses must only be used with devices that are non-fire printed.

SpectrAlert® Advance Series horns are designed to simplify installations to provide primary and secondary signaling for fire and security applications.

L-Series 2-wire horn strobes include a variety of features that increase their application versatility while simplifying installation.

SpectrAlert® Advance strobes include a variety of features that increase application flexibility and simplify installation, such as field-selectable settings, including candela, and automatic selection of 12 or 24V operation.