Shop TEKTONE SOUND & SIGNAL | Brands We Sell

Single-gang mounting
2 pole switches
Attractive, flame-retardant (UL 94V-0) plastic panel
Highly visible emergency labeling
May use with a central annunciator, or for local alarm
functions

The LI381 Corridor Light provides visual indication of calls when used with a nurse call system, emergency call system, or similar application. Emergency calls are indicated by the rapid flashing of the LI381 Corridor Light associated with the calling station. Normal calls produce a steady illumination.

The TEKTONE-PK543A Apartment Intercom Amplifier is a self-contained unit that does not require an external amplifier. The PK543A is designed for use with 3-, 4- or 5-wire apartment remote stations and provides amplification, control and power circuits needed to operate a complete apartment intercom system. Voice volume control and tone volume control are easily adjustable through the screwdriver opening on the front panel.

Additional functions of the PK543A include multiple door entrance operation with the PK502B; AC, DC or Maglock configurations with three selectable delayed door timing modes; post office door lock release; steady or warble call tones; power LED; selectable door button hold timeout; and selectable talk before door interlock (available for 4 -wire stations only).

The IR204E Apartment Intercom Stations combine modern styling with ease of operation to provide natural, clear voice communication and positive door- release operation. The stations are equipped with momentary-action push buttons for talk, listen and door operation. The attractive flame retardant ABS plastic faceplates are surface mounted, and blend with any setting. The advanced circuitry and versatility permit use in large or small buildings, with one or several entrances.

The SF337C Emergency Shower Switch is for any location where activation of an emergency signal is required. The design is such that it may be located anywhere in a shower, bath or tub room, regardless of environmental conditions. The combination of rubber-grommeted mounting screws, rubber mounting gasket, and completely sealed front face- plate make it waterproof (if properly installed). Electronic components are mounted on a circuit board, including an industry-proven reliable reed switch for call initiation. The activating magnet is mounted on the large pull-down lever, which is completely sealed in plastic. The indicator LED is also completely sealed.

The TekTone® PK502B Dual Entrance Control Unit provides a means to transfer apartment intercom panel and door release operations between more than one entrance. Pressing a call button on an entrance panel automatically transfers the voice and door release functions to that entrance. All PK502B control units are located at the amplifier location and do not need to be spread out.

The SF100C Single Bed Room Station includes a jack allowing the attachment of an SF301-series Call Cord. A call is registered at the nurse station, corridor light and corridor zone light (if installed) when the call cord button is used, or if the call cord is accidentally removed from the jack on the panel. The station includes a call-placed indicator that lights when a call is placed and a cancel button mounted on an attractive, flame-retardant (UL® 94V-0) plastic faceplate.

Surface mount frame designed to maximize mounting efficiency for nurse call systems.

The PK124K Battery Backup Kit provides continuous battery charging so that if power to system equipment is interrupted, standby operating power is provided for up to approximately 6 hours. The PK124K kit includes a transformer, a battery charger and two batteries—all preinstalled in a 19-gauge cold-rolled steel housing. Knockouts are included on all sides except the lid, to allow connection of electrical conduit from any direction. In addition, the lid has a knockout which can be used to install an optional key lock. The enclosed single- gang electrical junction box is galvanized steel with a stain- less steel cover plate.

The SF155B Emergency Station is for use in any location where activation of an emergency signal is required. All electronic components are mounted on a circuit board. The specially designed and mounted LED is completely sealed in plastic.
Due to the flexibility of its design, it may be used as a pull- cord emergency station, or a pull-down activated emergency station. The pull cord supplied may be used for emergency call activation, or if desired, the large 1.1” wide red pull- down lever may be used.