Shop Intrusion Accessories

The ELK-M1XEP is an Ethernet Appliance with a RS-232 Serial Port Interface. It may be used to connect a control in the M1 Family to an Ethernet network. It features email event notification and FIPS compliant encryption algorithms for security sensitive environments. It is powered by an ELK-P1216 12 Volts DC, 1.5 Amp plug-in power supply/adapter. A software setup utility is built into ElkRP for configuring the connection setup, network password, etc. The M1 Ethernet Interface is factory defaulted to obtain a dynamic IP address from a DHCP server (i.e. router, cable modem, etc.). It may optionally be setup with a static IP address.

Adds 16 hardwired zones (EOL resistor supervised) to the M1 Gold or M1EZ8 Controls. Operates from 4-wire data bus. Up to 12 of these can be used, increasing total zones (inputs) to 208.

Use this output module in partnership with your wireless security system. It provides eight low current (50 mA) programmable outputs.

Replacement 7V/1A power supply for IQ Panel 2, IQ Panel 2 Plus & IQ Remote (QW9104-840); includes 6’ wire with barrel connector

The SDM-100 Siren Driver is a compact, general purpose module for use where high dB sound output is required. The unique circuit design provides a high sound level output with a lower current requirement than comparable units.

An “active” RS-485 data bus hub designed for jobs where an M1Gold or M1EZ8 Control is retrofitting an older panel that has multiple homerun 4 conductor keypad/data wires. It splits the main 485 data bus into 4 managed 485 branches. Each branch can have 2 parallel home run cables for a total of 8 home runs. The end of each cable is EOL terminated to insure proper operation and supervision.

DSC CL-PP1 Battery pack for PG9200AX and PG9350SL photoelectric beam detectors. Contains 4× 3.6V 13.0Ah lithium batteries.

HSM3408 is an 8-zone expansion module intended to provide hardwired zone expansion to the Powerseries Pro. This I/O module is intended to connect to the panel using the Corbus interface. Inputs on this module are capable of NEOL, SEOL, DEOL and TEOL configurations, with customizable resistance thresholds and loop response times. The HSM3408 can be installed within the same metallic cabinet as the alarm controller/power supply or in a separate enclosure.

The RM-2 Relay Module is used as an end-of-line (EOL) power supervision module for 4-wire smoke detectors. The RM-2 is used with the Polarity Reversal Module PRM- 4W and DSC FSA-410 series smoke detectors. When the PRM-4W reverses polarity on the smoke detector loop to activate all smoke detector sounders, the RM-2 Relay will continue to operate normally (regardless of input power polarity).

Napco LOCK-8 Lock with 2-Key and Clip