Shop Intrusion Accessories

The IQP4BASE-GRY IQ Panel 4 Base Table Stand subwoofer offers a better sound experience for your security and smart home panel. Stream music from your favorite devices and listen to it loud and clear.  

The Alarm Controls RP-44 is a DPDT indicating shunt switch mounted to a single-gang satin stainless steel wallplate. The switch features an alternate action pushbutton that changes from black to orange when depressed. Remote wall plates with one or more push buttons that act as indicators and turn orange when pressed from black. Ideal for applications that call for zone shunting.

Retrofitting keypads an other system interfaces can be frustrating, especially when it requires patching a wall. The ELK-CPL Universal Cover Plate solves this problem for faster installations and a clean finished look.

The ELK-965 is a Low Battery Cutoff Module combined with a Master Power Switch. It is designed to work with virtually any 12 Volt control panel or power supply.
In the event of an extended power outage, the ELK-965 sensing circuit automatically disconnects the battery when the voltage falls below 10 Volts DC. This helps to prevent “deep discharging” of the battery. The convenient power switch permits the installer or user to easily disconnect both the Battery and the AC power from the control or power supply.

The MX920 Line Isolator Module is designed to be used on MX addressable controller loop circuits. The module monitors the line condition. If it detects a short circuit, it will isolate the affected section while allowing the rest of the addressing circuit to function normally. The module ensures that on a looped addressable system, no short circuit fault can disable more detection devices than would be lost on a conventional non-addressable fire/burg circuit.

GRI E-Z 58 50-W

The ELK-960 Delay Timer is designed to be an economical and flexible solution for any general-purpose timer application. The unit can be configured for use on 12 to 24V systems, with positive or negative trigger logic. Positive triggers can be as low as 4.5V. Setup is quick and easy with thumbwheel adjustment between 1 and 60 seconds. A quick jumper setting converts the time from seconds to minutes. The Timer can be configured to activate once for each trigger, or free-run as soon as power is applied. Relay can be configured to be normally on or normally off.

Lithium Battery for GEMTRANS2

IQ QR0074-840 Replacement Transformer for Wired to Wireless Converters including the popular IQ Hardwire 16-F. It operates at 16VDC, and it is easy to wire and plug into a wall outlet