NICE N. AMERICA M-8S, 15A STANDARD POWER CONDITIONER W/ SEQUENCER 120V
Item #:
NIC-M-8S
Product Info
NICE NORTH AMERICA
M-8S
With Power Sequencing, 9 Outlets, 1RU, 10Ft Cord
The Merit M-8S Power Sequencer is an affordable AC power solution for rack-mount systems requiring power sequencing. With 6 delayed outlets, it sequentially powers up your equipment, supporting up to a 15-amp load. The unit features 3 delayed outlet banks, each with 2 outlets, plus 2 unswitched outlets for always-on devices. Its built-in power filtration reduces noise caused by fans, lights, and power lines, ensuring cleaner sound. The sequenced outlets protect your gear by powering it up in stages, preventing speaker pops and potential damage. Known for its reliability, the Furman M-8S ensures consistent, clean power for your setup.
Features
- Standard level AC protection and filtering.
- Six sequenced rear panel outlets (in 3 groups), two unswitched rear panel outlets, and one front panel unswitched outlet.
- Momentary and Maintained sequencing via rear panel terminal block or front panel switch (momentary only).
- All settings and configurations available on rear panel.
- 15 amp rating.
- Three year limited warranty.
Specifications
- Line Voltage
120 (Volts) - AC Cord
14AWGx3, 10 feet, black, fixed, NEMA 5-15P plug - Convenience Outlet (Front Panel)
1 Un-switched NEMA 5-15R - Rear Panel Outlets
2 Un-switched NEMA 5-15R (1 duplex) - Sequenced Rear Panel Outlets
6 Sequenced NEMA 5-15R (3 duplexes, each controlled by separate relay) - AC Surge Protection
Merit Class (sacrificial) - Spike Protection Mode
Line to neutral, zero ground leakage - Maximum Continuous Operating Voltage
130V RMS - Max Clamp Voltage
500 Volts Peak - Peak Impulse Current
12,000 Amps - Energy Rating (2 X 820µS)
225 Joules - AC Filtering
Pi LCR Filter - Noise Attenuation
>26dB, 100 Khz to 1 MHz - Operating Temperature Range
5°C (40°F) to 40°C (105°F) - Humidity Range
<90% rH (Relative Humidity) - Rocker Switch
Front panel, Sequence (ON, OFF) - Thermal Circuit Breaker
Front panel, push to reset - Front Panel Indicators
Delay 1, Delay 2, Delay 3, Power, Protection OK - Control/Status/Triggering (Rear Panel)
Rear Panel DIP Switches: 12V Mode On/Off, GND Mode On, Momentary/Maintained - Potentiometer
Rear panel, time calibration fine-tune delay adjust - Remote Terminal
+5-30VDC In, 12VDC (12mA) Out - Remote Terminal Connector
Phoenix type 4-Pin Connector with Screw terminals; +12V, STAT, REM, GND (Class 2 Wiring) - Size
1.75” x 19.00” x 6.5” (HWD) – ANSI 1RU - Mass
5.3 lbs. - Power Consumption (No Load)
5 Watts - Safety Agency
C/CSA/US
Export To PDF